Connecting Power to the SafeGuard Controller
This section describes how to connect power to the AC and DC power input connections
on the rear panel of the SafeGuard Controller. An AC power cord is provided for each AC
power input on the SafeGuard Controller. For the DC power input, you must attach an
appropriate three-wire cable to the provided DC connector.
AC Power
To connect the SafeGuard Controller to an AC power source, follow these steps:
1
Connect an AC power cord to an AC power connector on the SafeGuard
Controller rear panel, as shown in
Figure 10 Connecting AC Power Cords (Model ACAC Shown)
Connect the other end of the power cord to a grounded AC outlet.
2
3
For an ACAC model in a redundant power configuration, repeat these steps to
connect the second AC power supply.
For more information about power requirements for the SafeGuard Controller, see
Appendix A, Technical
OmniAccess SafeGuard Controller Installation Guide
Figure
Specifications.
Chapter 2: Site Preparation and Installation
10.
CST_008
29