Getting Started; Battery Disposal - GRE CSPA Instruction Manual

GETTING STARTED

1. Suction head assembly
lnsert suction head into the body until two buttons of body
sides popping from holes of suction head. Please keep the
notch facing up.
2. Battery assembly and replacement
(1) Push the button "a" forward along the arrow direction, until it not stuck the slot of the
connector.(as picture A shown)
(2) Holding the body while reversing the connector , and removing the battery mounting
from the body.( as "b" in picture B shown)
(3) R emove the used battery, and replace new NI-MH battery( or AA Alkaline battery for
P1112) according to the sign of positive & negative pole of the battery mounting.( as
shown in picture C )
(4) lnstall the battery mounting into the body(as picture D shown, pay attention the positive
& negative pole of the mounting(as picture d shown,)and the 2 springs ( as picture "d1"
shown )alignment.
(5) Twist the connector into the body in clockwise, until the button "a" can buckle in the slot
of connector. As picture E shown.
(6)It is really important that this zone is well closed
(7) Now you can use the cleaner according to the instruction normally.
A

BATTERY DISPOSAL

Your Rechargeable Pool Vacuum Battery is a NI-MH battery which must be
disposed of properly is required; please contact your local authority for information.
WARNING!
Never attempt to disassemble a NI-MH battery.
Remove all personal items such as rings, bracelets, necklaces and watches when
unwiring a NI-MH battery from the vacuum unit.
A battery can produce a short circuit current high enough to weld a ring (or like item) to
metal causing a severe bum.
Wear complete eye protection, gloves and protective clothing when removing the battery
pack.
Take care not to touch wires together or allow them to contact any metal items, which
would cause sparking and/or short circuit the battery.
e
B
2
D E