Getting Started; Charger Set Up; Handle Assembly - GRE HIMVCB50.18 Instruction Manual

GETTING STARTED

1. Charger set up

Note: This product can work only under water, if
out of water, it will stop working.
NOTE:
Charge the cleaner 5-6 hours prior to the
first use. Normally cleaner can be operated 90
minutes after fully charged.

2. Handle assembly

By arrow direction to assemble the body parts, and attention the SIGN from Open to Close.
(1). Portable handle
Connection into the product
itself. The portable handle is
used to pick up VCB50 and
clean the wall, step, seat,
cornor.Fig[A]
3. Suction head assembly
Insert the Suction Head directly to the suction hole of the cleaner tightly by hand.
In order to have the better suction effect, please operate the
electric cleaner as the following instructions:
(1) Insert the suction head when suction the small pebbles and
leaves, as the picture "A" shows.
NOTE: The Vacuum head can be lock and unlock, When the
vacuum head is not locked, it can be rotated in 360 degrees
and make the cleaning work more conveniently. Fig[a1][a2]
(2)No need to insert the suction head onto the electric cleaner
when suction the stones and other large garbage and so on, as the
picture "B" shows.
(2). Telescopic pole（not
included）assembly
VCB50 can also connect
to standard telescopic
poles by pictures.Fig[B]
A
(1)Plug one end of the charger into the
socket, and the charger is green.
(2)Then, plug one end of charger to
VCB50, the charger is red, the charger is
working now.
(3)After charging 5-6 hours, the charger
becomes green, and VCB50 is fully charged.
(4)Now, it is time to work
(3). If needed, the pole can be
installed in the direction as the
picture "C" and "D".
B
D
C
a1
lock
A
a2
unlock
B