Controls; Pan Mixer Control Box - REED M2200 Technical Manual

OPERATION and MAINTENANCE

CONTROLS

PAN MIXER CONTROL BOX

1. System ON/OFF (Green Rotary Switch w/light)
• SWITCH POSITION TO THE LEFT = OFF CONDITION
• SWITCH POSITION TO THE RIGHT = CONTROL ON LIGHT SHOULD COME ON
2. Horn Switch (Green Button)
• WHEN PUSHED THE HORN SHOULD SOUND AND THE RED 'E' STOP LIGHT SHOULD
STOP FLASHING (Note, the MOTOR SWITCH MUST BE IN THE OFF POSITION)
3. Mixer Paddle ON/OFF (Green Rotary Switch w/light)
• THIS SWITCH IN THE "ON" POSITION WILL START THE MIXER PADDELS TURNING
AS LONG AS THE LIGHT IS NOT FLASHING. IF FLASHING THE SYSTEM IS IN AN
"E" STOP CONDITION AND "MUST" BE RESET, BY CLEARING THE FAULT TURNING
OFF THE "MOTOR" SWITCH AND THEN SOUNDING THE HORN, AT THIS POINT THE
SYSTEM SHOULD BE READY. (Note if using an electric power pack, the motor must be
restarted)
4. I-O (START (green)-STOP (red)) PUSH BUTTON SWITCH
THIS PUSH BUTTON SWITCH IS MEANT TO START AND STOP THE 50Hp. ELECTRIC
•
MOTOR OF THE POWER PACK. IT HAS AN OPORATIONAL LIGHT TO SIGNAL START.
'I' = START AND 'O' = STOP.
1
Rev *
2 3
www.reedpumps.com
(909)287-2100
4
22 of 51