Door Panel Installation - Bosch SHU53E Installation Instructions Manual

25"
(636 mm)
23-1/16"
(586 mm)
Figure 15/Ilus. 15
Figure 16/Ilus. 16
Figure 17/Ilus. 17
18
Door Panel Installation | Installation Panneau de Porte | Instalación - Panel de la Puerta

DOOR PANEL INSTALLATION

SHU Models - Accessory Panel
Installation
1/4" max.
If you have an SHU model and have
(6 mm)
ordered an accessory panel kit, install
the panel prior to sliding the dish-
washer into place. The panel dimen-
sions are shown in Figure 15.
SHI Models - Panel Installation
SHI models come with additional
mounting hardware and a template
sheet with installation instructions. The
stainless steel models of the SHI
series also come with two extension
pieces. The extension pieces are used
to match the control panel height
(Figure 16, "B" dimension) to the
horizontal drawer line of the cabinets,
and must be installed as shown
the template sheet. The standard piece
is used for drawer heights up to 6"
(152mm); the long piece is used for
drawer heights greater than 6"
(152mm) but 6-7/16" (164mm) or less.
If your drawers are taller than 6-7/16",
you can either slide the extension piece
in as far as it will go, or remove it and fit
the door panel directly below the control
panel.
SHI/SHV Models - Panel Installation
SHV models come with additional
mounting hardware and a template
sheet that will show you how to mount
the panel. One side of the template
shows how to mount a one piece
panel; the other side shows how to
mount a two piece panel. Decide which
type of installation you want before
proceeding with the installation.
Dimension
(SHI & SHV)
(SHI & SHV)
Fig. 17
Panel Dimension
20 11/16" - 25"
D (SHI)
(526mm - 635mm)
E
27 3/16" - 30 5/16"
(690mm - 770mm)
F
23 3/16" - 23 3/8"
(589mm - 594mm)
E n g l i s h
in on