Electrical Wiring - LG MULTI V WATER IV ARWV100DAL4 Installation Manual

Electrical Wiring

Electrical Wiring
Areas of Caution
1. Follow ordinance of your governmental organization for technical standard related to electrical equipment,
wiring regulations and guidance of each electric power company.
WARNING
Be sure to have authorized Electrical engineers do electric work using special circuits in accor-
dance with regulations and this installation manual. If power supply circuit has a lack of capacity
or electric work deficiency, it may cause an electric shock or fire.
2. Install the outside unit transmission line away from the power source wiring so that it may not affected by electric
noise from the power source. (Do not run it through the same conduit.)
3. Be sure to provide designated grounding work to outside unit.
CAUTION
Be sure to correct the outside unit to earth. Do not connect earth line to any gas pipe, water pipe,
lightening rod or telephone earth line. If earth is incomplete, it may cause an electric shock.
4. Give some allowance to wiring for electrical part box of indoor and outside units, because the box is some-
times removed at the time of service work.
5. Never connect the main power source to terminal block of transmission line. If connected, electrical parts will
be burnt out.
6. Use 2-core shield cable for transmission line.(O mark in the figure below) If transmission lines of different
systems are wired with the same multiplecore cable, the resultant poor transmission and receiving will cause
erroneous operations. (
7. Only the transmission line specified should be connected to the terminal block for outside unit transmission.
Outside Unit
Outside Unit
2-core shield cable
36 36 Outside Unit Outside Unit
mark in the figure below)
Indoor Indoor
Unit Unit
Remote Remote
control control
Indoor Indoor
Unit Unit
Remote Remote
control control
Outside Unit
Outside Unit
Multi-core cable
Indoor Indoor
Unit Unit
Remote Remote
control control
Indoor Indoor
Unit Unit
Remote Remote
control control