Samsung AM JXVAF Series Installation Manual page 80

Setting outdoor unit option switch and key function
Optional item Input unit SEG1 SEG2 SEG3 SEG4
Fan speed
correction for Individual
outdoor unit
Silent mode Main
High-head
Main
condition setting
Long-pipng
condition
setting (Setting
Main
is unnecessary
if high-head
condition is set)
Energy saving
setting
Main
(A type PBA)
80
0 0
0 6
0 1
0 0
0 1
0 2
0 3
0 4
0 7
0 5
0 6
0 0
0 1
0 8
0 2
0 3
0 0
0 1
0 9
0 2
0 0
1 0
0 1
Function of the option
Factory default
Increase fan speed
Disabled (Factory default)
LEVEL 1 / Auto
LEVEL 2 / Auto
LEVEL 3 / Auto
LEVEL 4 / External contact
LEVEL 5 / External contact
LEVEL 6 / External contact
Disabled (Factory default)
Level 1 of height difference
type 1 (Indoor unit is lower
than outdoor unit)
Level 2 of height difference
type 1 (Indoor unit is lower
than outdoor unit)
Height difference type 2
(Outdoor unit is lower than
indoor unit)
Disabled (Factory default)
LEVEL 1
LEVEL 2
Disabled (Factory default)
Enabled
Remarks
Increase the outdoor unit's fan
speed to maximum value
Do not use
this option in
CAUTION
an ambient
temperature over
54 °C. Failing to do
so may overheat the
fan motor, causing it
to stop operating.
Enables the silent mode for night-
time in cooling mode (It operates
automatically depending on the
temperature.)
However, if the external contact
interface module (MIM-B14) is
used, entering the silent mode is
available with contact signal in
cooling and heating mode.
(A type PBA : this function is used
in cooling mode.)
When outdoor unit is located
40~80m above the indoor unit
When outdoor unit is located over
80m above the indoor unit
When indoor unit is over 30 m
above the outdoor unit
When equivalent length of
farthest indoor unit from
the outdoor unit is between
100~170m
When equivalent length of
farthest indoor unit from the
outdoor unit is over 170m
Energy saving mode triggers
when the room temperature
reaches desired temperature
while operating in heating mode.