Searching For Your Component's Code - Panasonic ShowStopper PV-HS3000 Operating Instructions Manual

Searching for Your
Component's Code
If your component does not respond to the Hard Disk Recorder remote
after trying all of the codes listed for your brand, or if your brand is
not listed, try searching for your code.
For example, if you try all of the codes for your TV and cannot get the
Hard Disk Recorder remote to operate your TV, follow steps below.
1
Turn on your TV with the Hard Disk
Recorder off.
2
Press TV.
3
Hold down CODE SET until the remote's red
LED blinks twice, then release.
4
Press 9 - 9 - 1.
5
Slowly alternate between pressing POWER*
and TV until your TV turns OFF.
• Make sure that the Hard Disk Recorder remote is
aimed at your TV during the search.
• You may have to press this sequence of buttons
(POWER* then TV) up to 100 times to search the
entire library of codes.
* If you are searching for your VCR, or DVD player code,
you may want to use PLAY instead of POWER to search
for your code. When your VCR starts to play, press CODE
SET to lock in your code.
6
When your TV turns OFF, press CODE SET
to lock in the code for your TV.
• Your Hard Disk Recorder remote is now
programmed to operate your TV.
NOTE
• To search for the codes of your other components, repeat
steps 1~6, and substitute the appropriate device button (TV,
SAT/CABLE, or VCR/DVD) for the component.
PanaHDR- P42-.p65 43
Red LED
3
6
5
VCR/DVD
SAT/CABLE
2
5
4
PLAY
00/12/01, 16:40
CODE SET
POWER
TV
Number
Buttons
43