Learning The Codes Programmed Into The Remote; Re-Assigning Component Mode Buttons - Panasonic ShowStopper PV-HS3000 Operating Instructions Manual

Universal Remote Control

Learning the Codes Programmed Into the Remote

If you set up the Hard Disk Recorder remote by following "Searching for Your
Component's Code" on page 43, you may want to figure out which four-digit
code is operating your equipment. Use this procedure after you set up your
components to find out which four-digit code is operating your equipment.
For example, to find out which code is operating your TV after setting up
your TV, follow steps below.
1
Press TV.
2
Hold down CODE SET until the remote's red
LED blinks twice, then release.
3
Press 9 - 9 - 0.
4
Learn your code.
1) For the first digit of your four-digit code, press 1 and
count the number of times the red LED blinks on the
remote.
2) For the second digit, press 2 and count the number
of times the red LED blinks on the remote.
3) For the third digit, press 3 and count the number of
times the red LED blinks on the remote.
4) For the fourth and final digit, press 4 and count the
number of times the red LED blinks on the remote.
• If the LED does not blink, the digit is zero.
NOTE
• To find out the code for your other components, repeat steps
1~4, and substitute the appropriate device button (TV, SAT/
CABLE, or VCR/DVD) for the component code you wish to learn.
Re-assigning Component Mode
Buttons
You can program the Hard Disk Recorder remote component mode
buttons (TV, SAT/CABLE, or VCR/DVD) to control other home
entertainment components.
For example, to control a TV, a cable box, and a DVD player, you will need to
re-assign the VCR button to operate the DVD player, follow the steps below.
a
Hold down CODE SET until the remote's red
LED blinks twice, then release.
b
Press 9 - 9 - 2.
The red LED will blink twice.
c
Press VCR/DVD twice.
You can now program the VCR/DVD button for your DVD player.
d
See "Setting Up Your Components" on page 42.
To reassign other component mode buttons...
Repeat steps a~d by substituting the button sequence from
the list of popular components at right.
44
PanaHDR- P42-.p65
The red LED will blink twice.
44
(continued)
Red LED
2
a
c
SAT/CABLE
1
3
4
b
Reassigning device keys
TV as 2nd Press: CODE SET
VCR button 9-9-2-VCR-TV
TV as 2nd Press: CODE SET
CABLE button 9-9-2-CABLE-TV
TV back to TV Press: CODE SET
9-9-2-TV-TV
VCR as 2nd Press: CODE SET
TV button 9-9-2-TV-VCR
VCR as 2nd Press: CODE SET
CABLE button 9-9-2-CABLE-VCR
VCR back to VCR Press: CODE SET
9-9-2-VCR-VCR
00/12/01, 16:40
CODE SET
VCR/DVD
TV
Number
buttons