Siemens EQ.5 Extra Class Instruction Manual page 39

The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system�
The rinse procedure stops automatically
after about 1 minute�
● Empty the container and clean the milk
tube (6c)�
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher)�
Dismantling the milk system for cleaning:
● Pull the milk frother (6) forward out of the
appliance�
● Dismantle the milk frother into its indi-
vidual parts (6a to 6d) (see figure C at
the start of the operating instructions)�
● Clean the individual parts with a detergent
solution and a soft brush. If necessary,
soak in a warm detergent solution�
● Rinse all parts with clear water and dry
them�
● Reassemble all the parts and replace fully
in the appliance�
A Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed�
Cleaning the brewing unit
Clean the brewing unit regularly!
To pre­clean the brewing unit automatically:
● Select k by turning the rotary knob (15)�
● Place an empty glass under outlet (6a)�
● Press the start button (10)�
The appliance rinses�
In addition to the automatic cleaning
programme, the brewing unit (5a) should
be removed regularly for cleaning� (See
figure E at the start of the operating
instructions�)
● Switch the appliance off at the power on/
off switch O / I (9)� No buttons are lit�
● Open the door (5b) to the brewing unit�
● Slide the red lock (5e) on the brewing unit
(5a) completely to the left�
● Press the eject lever (5d) down fully� The
brewing unit is released�
● Grasp the brewing unit (5a) by the
recessed grips and remove carefully�
en
35