Oracle MICROS 700 Series Setup Manual page 42

Figure 7-3 Removing the Bridge Battery Cover
Carefully remove the battery from the compartment until you can access the
4.
connector cable. Use your fingers or a gripping tool to carefully separate the
connector. Make sure you hold and pull the plastic connectors and not the wires.
After disconnecting the battery, set it aside.
Figure 7-4 Battery Connector Cable
Connect the replacement battery. Tuck the excess battery wire into the casework
5.
and place the battery in the battery compartment.
Replacing the Bridge Battery in the MICROS Tablet 720
Chapter 7
7-6