Gilat Satellite Networks SkyEdge II Installation Manual page 5

About This Manual
This section describes the objectives, audience, document layout and conventions of
the SkyEdge VSAT Installation and Monitoring manual.
Objectives
This manual provides detailed instructions how to configure, install and monitor the
operation of the SkyEdge II IP VSAT.
How to Use This Manual
This manual is to be used by a trained installer in order to configure and install a
VSAT. The step-by-step procedures are to be closely followed in order to ensure that
he configuration and installation will be successful.
Audience
This manual is designed for trained personnel who will be responsible for the
configuration, installation and monitoring of VSATs in a SkyEdge network.
Organization
The table below contains a list of the chapters in the manual, the chapter titles and a
short description of the material contained in each chapter.
SE VSAT Install and Monitor
May, 2007
Chapter Chapter Title
Chapter 1 Introduction and
Overview
Configuring the VSAT
Chapter 2
VSAT Installation
Chapter 3
Regulatory
Chapter 4
Requirements
Proprietary and Confidential
SkyEdge II VSAT Installation and Monitoring
Description
Contains a brief description of the VSAT.
Contains detailed instructions on how to
configure the VSAT using the SkyManage web
page.
Instructs how to connect and boot-up a VSAT to
a previously pointed antenna and how to ground
the VSAT. Shows how to use the VSAT as a
pointing device. Contains instructions on how to
broadcast a CW from the VSAT.
Regulatory Requirements that need to be
included in this document
iii