Figure 9: Setup (Compressed View) - Gilat Satellite Networks SkyEdge II Installation Manual

3. Enter all of the configuration parameters as shown in Figure 10 and explained in
SE VSAT Install and Monitor
May, 2007
The password above is the default. Check with your hub operator to
verify that the password has or has not been changed
Result: The Setup page opens (Figure 9).

Figure 9: Setup (compressed view)

Figure 9 hides all of the specific parameters in order to view the entire
page.
Table 1.
Parameters marked with an asterisk (*) must be typed in the field. All
other parameters are selected from the drop-down list.
Each of the parameters has a pop-up with the valid range.
If an out of range value is used a warning will appear next to the
parameter as shown below.
Proprietary and Confidential
SkyEdge II VSAT Installation and Monitoring
N
OTE
N
OTE
N
OTE
8