Removing The Ac Power Supply - Cisco VG410 Hardware Installation Manual

Removing the AC Power Supply

1
2
3
4
5
Removing the AC Power Supply
To remove an AC power supply from the voice gateway, perform these steps:
Step 1
Read the safety warnings section of this document.
Step 2 Shut down the device before removing the power supply.
Step 3
If in use, remove the Velcro strap securing the power supply cable to the power supply latch.
Cisco VG410 Voice Gateway Hardware Intallation Guide
28
Setting up the Power Supplies
Handle
Velcro strap
Latch tab
Status LED
Power socket