Choosing A Location - Insignia NS-FWM27W1 User Manual

Choosing a location

WARNINGS:
• Don't install your washer in areas where water may freeze because your washer
always retains some water in its water valve, pump, and hose areas. Frozen water
can damage the belts, pump, hoses, and other components.
• Never install on a platform or weakly supported structure.
Selecting the correct location for your washer improves performance and
minimizes noise and possible washer "walk." Your washer can be installed under a
custom counter or in a basement, laundry room, closet, or recessed area. See
Drainage requirements on page 21. You should also consider a companion
appliance (dryer) location requirements.
For best performance, you need:
• A water heater set to deliver 120° F (49° C) water to the washer.
• A grounded electrical outlet located within 6 ft. (1.8 m) of where the power
cord is attached to the back of the washer. See Electrical requirements on
page 20.
• Hot and cold water faucets located within 4 ft. (1.2 m) of the hot and cold
water fill valves, and water pressure of between 0.05MPa~1MPa.
• A level floor with a maximum slope of 1 in. (25 mm) under entire washer. Don't
install your washer on soft floor surfaces, such as carpets or surfaces with foam
backing.
• A sturdy and solid floor to support the washer with a total weight (water and
load) of 200 lbs. (90 kg)
Make sure that the location is:
• Away from direct sunlight. Direct sunlight can raise the water temperature,
which may cause safety risks.
• An area where the temperature is above 32° F (0° C).
• Away from the heat resources such as coal or gas. Heat sources can raise the
water temperature, which may cause safety risks.
16
INSTALLATION INSTRUCTIONS
www.insigniaproducts.com