Step 5: Power Your Washer; Step 6: Run A Test Cycle - Insignia NS-FWM27W1 User Manual

INSTALLATION INSTRUCTIONS

Step 5: Power your washer

• Plug the power cord into a well-grounded, 3-prong, 120 Volt 60 Hz approved
electrical outlet, protected by a 12-amp fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the power cord.
WARNINGS:
• Make sure that the power voltage at your location is the same as the voltage on
your washer's rating label.
• Do not use a multi-purpose plug or socket.
• Do not use an adapter.
• Do not use an extension cord.
• Do not touch or pull out the plug with a wet hand.
• When you unplug the power cord, hold the plug not the power cord.
• If power cord is damaged or has any sign of being broken, replace the cord.

Step 6: Run a test cycle

Run a test cycle to make sure that your washer is correctly installed.
Leave the tub empty.
1
Press the Power button to turn on your washer.
2
Turn the cycle selector to select the Rinse&Spin cycle.
3
Press the Start/Pause button to start the test cycle. Your washer shouldn't
4
rock or vibrate excessively when water fills the tub, or when washing or
spinning. Your washer should drain well during the spin cycle.
CAUTIONS:
• If you detect any water leaks while your washer is filling or draining, check the
water connections. See Step 2: Connect the water hoses on page 22 or Step 3:
Connect the drain hose on page 24.
• If your washer rocks or vibrates excessively, level it again. See Step 4: Level your
washer on page 28.
www.insigniaproducts.com
NS-FWM27W1
29