Using The Emergency Door Release; Unfreezing Your Washer - Insignia NS-FWM27W1 User Manual

OPERATING INSTRUCTIONS

Using the emergency door release

If the power fails or other circumstances prevent you from opening the door, you
can use the emergency cord to open the door.
WARNING:
You can't use the emergency cord when you washer is running. If you must open the
door, turn your washer off and wait for the water to cool before you use the
emergency cord.
Open the filter door located on the bottom right of the front of your washer.
1
Gently pull the emergency cord down.
2
Note: Don't pull hard on the cord. You might break it. Pull gently.
Open the your washer's door.
3
Restore the cord to its original position, then close the filter door.
4

Unfreezing your washer

If the ambient temperature drops to freezing (32° F [0° C]), any water in the pipes
or water hoses may freeze.
Unplug the power cord.
1
Wash the water faucets with warm water to loosen the inlet hose.
2
Remove the water hoses and immerse them in warm water.
3
Pour warm water into the washing drum and wait for 10 minutes.
4
Reconnect the water hoses to the water faucets and make sure that there are
5
no leaks.
Run your washer on the Drain Only cycle to remove any water you added.
6
Emergency release cord
www.insigniaproducts.com
NS-FWM27W1
45