Insignia NS-FWM27W1 User Manual page 23

INSTALLATION INSTRUCTIONS
Connect the ends of the water supply hoses to the water supply intake
4
connections at the back of your washer. The water supply hose connected to
the hot faucet must be connected to the hot water supply intake and the
water hose connected to the cold faucet must be connected to the cold water
supply intake.
Back of washer
Note:
• If you don't want to use the hot water faucet or you don't have a hot water faucet,
you have to adjust the Temp. setting to cold, or your washer will have an Error code
E10.
• If you only have cold water faucet, we recommend that you buy and install a
T-branch pipe.
Tighten the fittings by hand until they are snug, then tighten them an
5
additional two-thirds of a turn with pliers or a wrench.
CAUTIONS:
• Don't overtighten the fittings or apply tape or sealant to the faucets or water
supply intakes. This can damage the fittings.
• Make sure that the water supply hoses aren't twisted or bent. A bent or twisted
hose can leak and cause an electric shock because of water leakage.
Turn on the hot and cold water supplies, then check all the water supply
6
intake connections and the faucets for water leaks.
www.insigniaproducts.com
NS-FWM27W1
Hot water supply
Cold water supply
Water supply hoses
23