Set Up The Dragen Server - illumina DRAGEN v3 Site Prep And Installation Manual

Illumina DRAGEN Server v3 Site Prep and Installation Guide

Set Up the DRAGEN Server

This section provides information on installing the DRAGEN Server v3. Before beginning, make sure that you
have all the components and your facility meets the necessary requirements. For more information, see
Shipping Box Components on page 1
The following components are not included with the DRAGEN Server v3 and required to set up the sever:
Monitor with a HDMI input
u
HDMI cable
u
Keyboard with a USB input
u
Mouse with a USB input
u
Two USB cables
u
Install the Server Racks
Use the following instructions to mount the DRAGEN Server v3 to your server rack.
1 Pull the mounting bracket rail out from the rail assembly until you reach the safety lock.
2 Press the safety lock trigger down, and then remove the mounting bracket rail from the rail assembly.
3 Release the sliding lock on both ends of the rail assembly.
Document # 1000000097923 v02
For Research Use Only. Not for use in diagnostic procedures.
Facility Requirements on page
and 2.
6