Configure External Storage - illumina DRAGEN v3 Site Prep And Installation Manual

Illumina DRAGEN Server v3 Site Prep and Installation Guide
:wq!
8 To restart the chrony daemon, enter:
systemctl restart chronyd
9 Check the health of the local time server. Enter:
timedatectl
10 Make sure that DRAGEN can synchronize with the local NTP server using the ntpdate command.
Example:
ntpdate -q 192.168.1.1

Configure External Storage

The DRAGEN Server v3 storage uses PCIe NVMe: Micron 9300 max series 6.4TB NVMe U.2 SSD and SATA
III SSD: Transcend 2.5" 256GB SATAIII SSD. Use the instructions in this section to mount an external storage
server.
Mount NFS on DRAGEN Server
1 Locate your NFS server and share name.
Example:
Server: 192.168.100.100
u
Share name: /share
u
2 Use server:/share name for the mount location.
Example:
192.168.100.100:/share.
3 To map this share to /mnt on the DRAGEN Server v3, run the following command as root on your
system:
mount -t nfs 192.168.100.100:/share /mnt
4 Share is mounted at 192.168.100.100:/share to the local file system under /mnt.
Mount SMB/CIFS on DRAGEN Server
1 Locate your SMB/CIFS server and share name.
Example:
Server: 192.168.100.100
u
Share name: /share
u
2 Locate the user name and password required to access this share (if applicable).
Example:
User name: sbsuser
u
Password: sbs123
u
3 Use //server/share name as the mount location.
Example:
//192.168.100.100/share.
4 To map this share to /mnt on the DRAGEN Server v3, run the following command as root on your local
system:
Document # 1000000097923 v02
For Research Use Only. Not for use in diagnostic procedures.
13