Configure Bmc - illumina DRAGEN v3 Site Prep And Installation Manual

Illumina DRAGEN Server v3 Site Prep and Installation Guide
Figure 1 Rear of DRAGEN Server v3
A Power supply inlet
B RJ45 10 GB Port 2
C RJ45 10 GB Port 1
D 10 GB SFP+ Port 2
E 10 GB SFP+ Port 1
F BMC
G HDMI Port (monitor)
Install the DRAGEN Server v3 License
You can activate the DRAGEN Server v3 by installing the USB license key as follows. You must activate the
server before proceeding.
1 Connect the power supply to the AC inlet, and then to a wall outlet.
2 Locate the USB license key in the delivery box.
3 Plug the USB license key into any USB port on the back of the server.
4 Connect the power cord to the power supply inlet, and then to the wall outlet.
The server powers on automatically.
5 Connect your monitor to the DRAGEN Server v3 using the HDMI port.
6 Connect your keyboard to the DRAGEN Server v3 using any unoccupied USB port.

Configure BMC

You can connect to the Baseboard Management Controller (BMC) to provide remote monitoring and control
for Illumina Technical Support.
1 Log in as root.
2 Enter the root password provided in the DRAGEN welcome email. If you have not received your sign in
credentials, contact Illumina Customer Service.
3 If signing in for the first time, reset your password.
Passwords must contain at least 10 alphanumeric characters and two special characters.
Document # 1000000097923 v02
For Research Use Only. Not for use in diagnostic procedures.
10