Pride Mobility Litestream XF LTD Manual page 18

I V . C O M F O R T A D J U S T M E N T S
Seatback Height
You can adjust the seatback to one of two different
heights. The adjustment range is 5 cm (2 in.) in 2.5-cm
(1-in.) increments. See figure 27.
To adjust the seatback height:
1. Remove the screws and nuts that fasten the seat
canes to each side of the frame.
2. Slide the seat canes up or down to the desired height.
3. Use the screws and nuts to refasten the seat canes
to the frame.
Seatback Angle Adjustment (Optional)
Your wheelchair may be equipped with angle adjust-
able back canes that allow you to adjust the seatback
to one of five different angles. The angle adjustment
range is 85°-105° in 5° increments. See figure 28.
To adjust the seatback angle:
1. Remove the top screw and nut from the back cane
and loosen the lower screw. See figure 27.
2. Rotate the eccentric washer to the appropriate
position that represents the desired angle. See
figure 28.
3. Reinstall the hardware to its original position from
step 1.
Seat Angle (Dump) Adjustment
The position of the caster wheels affects the angle
(dump) of the seat. By changing the location of the
caster wheel on the fork, you change the seat angle.
See figure 33.
NOTE: You can also adjust the seat angle by raising or
lowering the drive wheel. See "Drive Wheel Position."
To change the seat angle:
1. Remove the hardware that fastens the caster wheel
to the caster fork.
2. Reposition the caster wheel on the caster fork.
3. Reinstall the hardware that fastens the caster wheel
to the caster fork.
4. Repeat the procedure for the other side, making
sure both caster wheels are adjusted to the same
position.
WARNING! Changing the seat angle
may adversely affect stability and
cause the wheelchair to tip over.
Litestream XF LTD
NUTS
Figure 27. Seatback Height Adjustment
ECCENTRIC
WASHER
SCREW
Figure 28. Seatback Angle Adjustment
Figure 29. Single-post Armrest Removal
www.pridemobility.com
BACK
CANE
85
NUT
SCREWS
SIDE-
FRAME
90 95
100 105
RELEASE
LEVER
25