Pride Mobility Litestream XF LTD Manual page 12

I V . C O M F O R T A D J U S T M E N T S
WARNING! If your wheelchair is equipped with a transit securement system, the drive wheel
height should only be adjusted by a Quantum Rehab Provider or a qualified technician.
NOTE: If the caps are removed to obtain the desired center of gravity, make sure that they are replaced in the
same hole on each side of the wheelchair to maintain the same STF height on each side.
To change drive wheel height:
1. Remove the drive wheel. If your wheelchair is equipped with a quick-release drive wheel, press the quick-
release button and pull the drive wheel off. See figure 12. If your wheelchair is equipped with a bolt-on drive
wheel, remove the hubcap, and then remove the nut and bolt. See figure 13.
2. Pull the drive wheel off of the wheelchair.
3. Reposition the drive wheel up or down to the desired position.
NOTE: The wheel height can be adjusted to 3 different positions. See figure 16A and 16B for more information
on seat-to-floor heights.
4. Reinstall the drive wheel. Make sure that the wheel axle is snapped securely into the axle bracket or the
hardware is reinstalled and securely tightened, depending on how your wheelchair is equipped.
NOTE: Make sure that the caps on both sides of the wheelchair are inserted into the same positions on the drive
wheel bracket. This will ensure that both drive wheels are adjusted to the same height.
NOTE: Make sure that both drive wheels are adjusted to the same position.
WARNING! Ensure the quick-release axles are properly secured.
Litestream XF LTD www.pridemobility.com 19