Service Interface - Phoenix Contact AXL F BK PN Manual

Reset button
The reset button is located beneath the top marking label on
the bus coupler.
1
Figure 6 Reset button
1 Labeling field
2 Reset button
The reset button has two functions:
– Restarting the bus coupler
– Resetting of the default settings
Holding down the button during the initialization phase re-
stores the default settings.
If you wish to restore the default settings, proceed as fol-
lows:
• Disconnect the power to the module.
• Press and hold the reset button.
• Switch on the power.
The LEDs indicate the initialization phase:
LED State
RDY OFF
RDY Yellow ON
RDY Green
• When the RDY LED lights up green, release the button.
The default settings are restored.
105731_en_01
2
Meaning
Starting firmware
Initializing firmware
Initialization complete
www.phoenixpowersupply.co.uk
Documentation
How to assign the PROFINET names and the
IP address as well as how to startup a device
within a PROFINET system is described in the
following documents:
- "PC WORX" quick start guide
- "Configuring INTERBUS devices in a
PROFINET network using the example of
STEP 7" quick start guide
For the order designations, please refer to the
odering data.
The documentation can be found on the Inter-
net at phoenixcontact.net/products.
12

Service interface

The service interface is located beneath the top marking
field on the bus coupler.
The service interface is used for diagnostics, for parameter-
ization, and for testing I/Os before startup.
1
Figure 7 Service interface
1 Labeling field
2 Service interface
AXL F BK PN
2
11
PHOENIX CONTACT