Conditions For Mounting To Wall; Mounting To Wall - Dynamic Mounting Slim Down and Out Swivel Mount Assembly & Installation Directions

Conditions for Mounting to Wall

1. The TV must be centered on the mount to avoid leaning.
2. The mount is designed to attach to standard 2 x 4 or larger wall studs. If the wall isn't sturdy enough then more support will need
to be added, consult an expert.
3. The mount must be securely fastened to a structure that can support 4 times the total weight of the television and mount.
Dynamic Mounting assumes no responsibility for damage from an improperly installed mount.
4. The mounting holes need to be in the center of the studs, use a stud finder as needed.
5. 2 lag screws are needed in the top slots of the mount and 2 in the bottom slots.
6. 2 lag screws need to be on each side of the center of the mount and the center of gravity of the television.
7. You can double check these conditions are meant by;
o
Using the mount as a template, or
o
Downloading and printing the
o
The cardboard box the mount ships in has an outline of the bracket that attaches to the wall, cut out to use.
Note:
We recommend having 1 or 2 people help with this part.

Mounting To Wall

1. The television should be centered on the mount, if not the television will sag to one side. The heavier the TV and the more off
center, the more unlevel the TV will be through its range of motion. If your stud placement doesn't allow for the TV to be
centered, the Extra Wall Support
2. Mark the locations of the mounting holes by;
o
Using the mount as a template, or
o
Downloading and printing the
of the website, or
o
The cardboard box the mount ships in has an outline of
the bracket that attaches to the wall, cut out to use.
3. Once you know your location, pre-drill 1 of the top row of
mounting holes 2.5" deep using the ¼" drill bit.
4. Get someone to help hold the mount to the wall.
5. Figure 11 shows the correct order to put on the lag screw.
6. Use a 9/16" wrench to install the lag screw; do not tighten
all of the way down yet.
7. Level the mount as shown in Figure 8, Positioning Mount on
the Wall.
8. Mark and drill the other 3 holes 2.5" deep.
9. Install the lag screws and tighten until the mount is firmly
pressed against the wall. Do NOT over tighten.
Install Video at www.DynamicMounting.com/Install
Wall Mount Template off of the website, or
(sold separately) will give more side to side adjustment.
Wall Mount Template off
Figure 11, Lag Bolt and Washer Order
8