Positions Mount Will Stay At; Moving The Television Up And Down - Dynamic Mounting Slim Down and Out Swivel Mount Assembly & Installation Directions

Warning!:
Do Not Let Go of the TV Until the Motion has stopped on
its Own.

Positions Mount Will Stay At

The Slim Down and Out Swivel Mount has a range of positions the mount
will hold the TV at. The general range is shown in Figure 13. The mount
can always stay in the top position.
From the top position down 12" the mount can be set to stay but the angle
may not be vertical and the TV will not have a wide range of positions to stay
at. The Mount really isn't designed to hold the TV in this range.
From 12" to all of the way down the mount can be set to stay in a wide range
of positions. Depending on the weight of your TV the range will vary. For
lighter TVs (60 lbs and under) the mount may stay in the entire bottom range.
For Heavier TVs (80 lbs and over) the mount may only have a range of about
8".

Moving the Television Up and Down

If the counterbalance is set up correctly the TV should be able to be lifted all
of the way up into the top/locked position with reasonable effort. To unlock
from this position pull out on the bottom of the television. To get the
television all the way to the bottom position you may need to push down on
the television. If the TV pops back up from the desired bottom position,
reduce the counterbalance force. Typically, the force to lift the TV all of the
way up is approximately 20-30% of the weight of TV.
Figure 13, Positions Mount Will Stay At
Install Video at www.DynamicMounting.com/Install
10