Table Of Contents - Dynamic Mounting Slim Down and Out Swivel Mount Assembly & Installation Directions

CAUTION:
These wall mounting instructions and hardware are for mounting to wood studs only. It is up to you to verify that
the material supplied will work for your setup; other materials may need to be purchased by you. For concrete, brick or other
mounting materials consult an expert.
Consult your TV's owner manual before mounting your television, it contains relevant information.
Tools Needed

7/16" open ended wrench

1/2" box or ratchet wrench

9/16" box or ratchet wrench

1/4" Drill Bit

Drill

Tape Measure

Stud Finder

Level

Phillips Screwdrivers

A friend or 2, depending on how heavy
your television is
Parts Included

1 Slim Down and Out Swivel Mount (Two Stud
Version, unless Addendum Included)

1 Slim Swiveling Hook Plate

2 Slim TV Hangers with hardware shown in Figure 12
o
2 #10 Screw
o
2 #10 Washer
o
2 1/4" Nut
o
2 1/4" Washer

2 Crossbars with hardware shown in Figure 9
o
4 1/4" Nut

2 Paintable Plastic Covers

Table of Contents

Deciding the Swivel Setting .............................................. 4
Attaching Swiveling Hook Plate to Mount ......................... 5
Adjusting the Swivel Tension ............................................ 5
Determining Where to Put Mount ...................................... 6
Attaching TV Hangers to Television.................................. 7
Conditions for Mounting to Wall ....................................... 8
Mounting To Wall............................................................. 8
Attaching the Television to the Mount ............................... 9
Positions Mount Will Stay At .......................................... 10
Moving the Television Up and Down .............................. 10
Above Shelf Mounting .................................................... 11
Install Video at www.DynamicMounting.com/Install
Various Items (All in One Bag)

4 3/8" by 3" long lag screw with washer

4 Zip Ties

2 Adhesive Rubber Bumpers

1 1/2" Open-Ended Wrench (For attaching Swiveling
Hook Plate)

4 Lag Screw Cover

4 Washer for Lag Screw Cover
Fasteners for Mounting the Television to the TV Hangers
(All in One Bag)

4 M6 x 20 mm (.78") long Phillips head machine screw

4 M6 x 35 mm (1.38") long Phillips head machine screw

4 M8 x 20 mm (.78") long Phillips head machine screw

4 M8 x 35 mm (1.38") long Phillips head machine screw

4 1/4" tall plastic spacers

8 .1" tall plastic spacers

4 Steel M6 washers
Fasteners for Attaching Swiveling Hook Plate (Assembled
on the Left or Right Swivel Setting, remove if different setting
needed)

1 5/16" diameter x 7" Hex Head Machine Screw (Swivel
Pivot Bolt)

1 5/16" Nylock Nut (Swivel Pivot Nut)

2 5/16" Washers
Adjusting the Counterbalance .......................................... 12
Bump Stop ...................................................................... 12
Setting the Tilt in the Top Position .................................. 13
Setting the Tilt in the Bottom and Out Positions............... 13
Rubber Bumpers ............................................................. 13
Paintable Plastic Covers .................................................. 13
Wire Management ........................................................... 14
Maintenance ................................................................... 14
Warranty ......................................................................... 14
2