Surveon NVR2000 Series Quick Installation Manual

QUICK INSTALLATION GUIDE
Hardware Installation
Warning!
Tools Required
Only qualified server personnel should
install and service this product in order
to avoid risk of injury from electrical
shock and energy hazard.
Flat blade
Caution!
screwdriver
Observer all ESD (Electro-static Discharge)
procedure during installation to avoid
damage to the system and other
Accessories
components.
NVR2000 Network Video Recorder
•
Unpacking list
•
Quick installation guide
•
Client Installation CD/DVD
•
Slide Rails
•
Slide Bracket
•
Cable Tie
•
Power Cord
•
1 Unpack the subsystem
Preparing for Setup
The box should include two sets of rail assemblies, six rail mounting brackets and the
mounting screws you will need to install the system into the rack. Please check the package
content and follow the instruction below.
2 Rack-Mounting and Preparing Disk Drives
Adjusting the rack mounting rails
Measure the distance between the front and the rear rack posts.
1.
2. Attach a short bracket to the front side of the right outer rail
and a long bracket to the rear side of the right outer rail.
3. Adjust the short and long brackets to match
the rails to rack posts.
Q M0 N V R 2 E 2 R 1 1
© by Surveon Technology, Inc. All rights reserved.
NVR2000
Attaching the rack mounting rails to the enclosure
1 . Secure the short bracket to the front side of
the outer rail w/ 2 screws, and the long bracket
to the rear side of the outer rail w/ 3 screws.
2. Repeat the process to install another outer rail.
Phillips
screwdriver
Anti-static
wrist strap
Installing the enclosure to the rack
1. Install the server by lining up the rear of the
chassis rails with the front of the rack rails.
2. Slide the chassis into the rack rails, keeping
the pressure even on both sides (you may have
to depress the locking tabs when inserting).
3. When fully inserted into rack, you should hear a
click sound made by locking tabs.
Preparing the Disk Drives
The NVR2000 series requires at least two disk drives to be installed, to ensure RAID 1
configuration and to install the NVR OS in the first partition of the first virtual pool.
We recommend you to install the first two drives in slot #1 and #2.
The order of the drives does not matter.
Slot #1 (left) to #2 (right)
vpool1
vpool2
PWR
BUSY
ATTEN MUTE
ESC ENT
SSD
accelerator
vpool3
3 Drive Bay Installation/Removal
Accessing the Drive Bays
Please power-down the NVR2000 before accessing the drive bays.
Use caution when working around the SATA backplane. Do not
touch the backplane with any metal objects and make sure no
ribbon cables touch the backplane. Also, regardless of how
many SATA drives are installed, all four drive carriers must
remain in the chassis to maintain.
Mounting a Serial ATA Drive in a Drive Carrier
The SATA drives are mounted in drive carriers to simplify their installation and
removal from the chassis. These carriers also help promote proper airflow for the
system. For this reason, even empty carriers without drives installed must remain in
the chassis.
1. Install a new SATA drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
2. Secure the drive to the carrier with six screws.
Installing/Removing SATA Drives
1. To remove a carrier, push the release button located beside the drive LEDs.
2. Swing the colored handle fully out and use it to pull the unit straight out.