Multicolor Module Led Color Hierarchy; To Change A Module Group Flash Pattern Selection; Module Group Wires - Unsynchronized - Ecco 21 Series Installation And Operation Instructions Manual

**For AMBER/WHITE modules within the Arrowstik, WHITE is primary and AMBER is secondary.

To change a Module group flash pattern selection:

1. Power-up the lightbar and apply +power to a single level mode (see Table 2). The lightbar will flash the default pattern shown in Table 3.
2. Twist together the BLK/RED Pattern select wire in the 16 conductor cable and the wire of the Module group you want to change shown in
Table 5.
3. Momentarily touch the BLK/RED and group wire from step 2 to power to cycle through one pattern as detailed in Table 6. The pattern for
the module group configured will only be set in the level mode selected. Hold the wires to power for more than 4 seconds to return to the
default flash pattern.

Multicolor Module LED Color Hierarchy

Color Combination Primary
RED/BLUE RED
RED/AMBER RED
RED/WHITE RED
BLUE/AMBER BLUE
BLUE/WHITE BLUE
AMBER/WHITE** AMBER
TABLE 4

Module Group Wires - Unsynchronized

Function Wire Color Module Group
GRN/WHT Front Outboard
BLU/BLK Front Inboard
GRN Front Corner
BLK/WHT Rear Outboard
RED/WHT Rear Inboard
BLU/WHT Rear Center
BLU Rear Corner
BLK Rear End
ORG/BLK Takedown/Work Lights
WHT Alley
TABLE 5
Secondary
BLUE
AMBER
WHITE
AMBER
WHITE
WHITE
Page 9 of 20