Arrowstik Flash Pattern Selection; Arrowstik Flash Patterns; Arrowstik End Flash Pattern Selection; Arrowstik End Flash Patterns - Ecco 21 Series Installation And Operation Instructions Manual

Arrowstik Flash Pattern Selection

The CC Series Lightbar is designed to offer user selectable traffic directing and traffic warning flash patterns. Each of the ArrowStik® func-
tions (LEFT, CENTER-OUT, RIGHT or FLASH) can be programmed individually for unique sequences and flash rates. This allows the great-
est flexibility when controlling the various lightbar configurations available. The lightbar can be configured with 5, 6, 7 or 8 Module modules
and comes from the factory with the Building Fast pattern as the default for LEFT, CENTER-OUT and RIGHT. The default pattern for FLASH
is Driver's Side Cut – front, corner & alley.
To select a flash pattern for one of the four Arrowstik functions,
1. Power-up the lightbar and apply +power to a single Arrowstik mode (see Table 41) in the 16 conductor cable.
2. Momentarily touch the Pattern Select wire (BLK/RED) to +power to cycle through the flash patterns shown in Tables 13 and 14 below. Hold
for more than 4 seconds to return to the factory default.
Flash patterns marked with an asterisk (*) can be selected in Fast, Medium or Slow flash rate.

Arrowstik End Flash Pattern Selection

The lightbar can be ordered with two additional lamps positioned at the outermost ends of the ArrowStik. These two modules may be config-
ured for the End Flash function during ArrowStik operation. The factory default is the off sequence.
To configure Arrowstik End Flash:
1. Power-up the lightbar and apply +power to a single ArrowStik function - LEFT (RED), CENTEROUT (RED + ORG), RIGHT (ORG) or
FLASH (WHT).
2. Momentarily hold the BLK/RED and BLK wires to +power to increment to the next end flash sequence shown in Table 15. Hold for more
than 4 seconds to return to the factory default setting.
Arrowsik Left, Center-Out &
Right Flash Patterns
Order Flash Pattern
1 Building*
2 Building, 3-Flash*
3 Traveling Ball, 3-Flash*
4 Build/Collapse*
TABLE 13

Arrowstik End Flash Patterns

Order Multicolor Modules
1 Off
2 Alternating - Both
3 Alternating - Primary Only
4 Alternating - Secondary
Only

Arrowstik Flash Patterns

Order Flash Pattern
1 Drivers Side Cut - Front corner & alley
2 Drivers Side Cut - Rear corner & alley
3 Drivers Side Cut - Front outboard, corner alley
4 Standard Flash*
5 Quad Flash Standard
6 Simultaneous Flash*
7 Quad Flash Simultaneous
8 Even/Odd Flash*
9 Quad Flash Even/Odd
10 Left/Right Flash*
11 Quad Flash Left/Right
12 Travelling Ball Flash*
Single Color Modules
Off
Alternating
TABLE 15
TABLE 14
Page 13 of 20