Ecco Gemineye EC2014-C Installation Instructions Manual

Ecco Gemineye EC2014-C Installation Instructions Manual

Camera/monitor system
Hide thumbs Also See for Gemineye EC2014-C:

Advertisement

Introduction:
ECCO's Gemineye™ Camera Systems are designed to provide rear of
the vehicle information that may not be available to a driver relying
solely on a vehicle's standard rear view mirror system. A driver using a
properly installed and maintained rear view camera system in
conjunction with the standard mirror system, can be alerted to potential
safety hazards and thus take the appropriate action to prevent an
accident. This manual provides information about installation, function,
safety, maintenance, replacement parts, and warranty.
!
WARNING!
Failure to install or use this product according to manufacturers recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the
safety information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices
are essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that
s/he can operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use,
the vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open
trunks or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws
and regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.

Installation Instructions

Camera/Monitor System

Advertisement

Table of Contents
loading

Summary of Contents for Ecco Gemineye EC2014-C

  • Page 1: Installation Instructions

    Installation Instructions Camera/Monitor System Introduction: ECCO’s Gemineye™ Camera Systems are designed to provide rear of the vehicle information that may not be available to a driver relying solely on a vehicle’s standard rear view mirror system. A driver using a...
  • Page 2: Specifications

    Specifications: Camera EC2014-C 1/3” CMOS Color Image Effective Pixels: 725 x 488 Voltage Requirement Power Consumption Lens F=2.8mm / F=2.0 Lens Angle 120° Audio Light Sensor Auto Switch B&W Infrared LEDs 11 (10M Max. Visibility) Pigtail Connection: CAM Male 4 Pin Threaded Housing Aluminum Alloy Mech.
  • Page 3: Installation

    Installation, Wiring and Function Caution! When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle upholstery, etc. that could be damaged. Notes: 1. Larger wires and tight connections will provide longer service life for components. For high current wires it is recommended that terminal blocks or soldered connections be used with shrink tubing to protect the connections.
  • Page 4 Wiring: ECTC20-4 Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with insulation tape. Wrap tape tightly, overlapping by one-half widths so there are no gaps. Figure 2 2A INLINE FUSE SUPPLIED Red (Power) + 13 PIN FEMALE 13 PIN MALE Black (Ground) - White Trig.
  • Page 5 Monitors: Models EC5603-M and EC7003-M WARNING! To prevent accidental shock, DO NOT OPEN THE MONITOR CASE. Opening the monitor case will expose the inside of the monitor to conditions that could adversely affect performance. Any evidence of tampering with sealed components will void the warranty. Important! Do not expose the monitor to water, it is not waterproof.
  • Page 6 Installation instruction of using pedestal base 1. Select suitable position on vehicle and fix the base support. (Figure 6) 2. Fix the monitor to the base support and adjust the view angle. 3. Put on the sun-visor and connect the monitor with the AV and power supply conversion cable (Figure 7) Stick the base support onto the vehicle...
  • Page 7: Remote Control Operation

    Remote Control Operation...
  • Page 8 Monitor Parts Identification EC5603-M EC7003-M Color LCD Screen Light Level Sensor Remote Signal IR Receiver Camera Select Speaker Installation port for Volume Up center mount bracket Volume Down Power Menu Menu Selection and Display Mode...
  • Page 9: Menu Operations

    Menu Operations Press the Menu button on the remote control or the Menu button on the monitor screen. Press the Menu button several times to go from one menu to another. Use the channel up/down on the remote control or the down button on the monitor screen highlight a menu.
  • Page 10 Manufacturer Limited Warranty and Limitation of Liability: Manufacturer warrants that on the date of purchase, this product will conform to Manufacturer’s specifications for this product (which are available from the Manufacturer upon request). This Limited Warranty extends for twelve (12 ) months from the date of purchase.

This manual is also suitable for:

Gemineye ec5603-mGemineye ec7003-mEc2014-cEc5603-mEc7003-m

Table of Contents