To Change A Module Group’s Flash Pattern Rate Selection; Module Group Flash Rate Wires - Synchronized - Ecco 21 Series Installation And Operation Instructions Manual

After the module groups have a sequence selected, a flash pattern rate can be chosen. The default rates are as follows in TABLE 10.
To change a Module group's flash pattern rate selection:
1. Power-up the lightbar and apply +power to a single level mode (see Table 2) in the 16 conductor cable.
2. Momentarily touch the BLK/RED Pattern select wire and the appropriate Module group wire, shown in Table 11, to +power to cycle through
the flash pattern rates shown in shown in Table 12. Hold the wires to +power for more than 4 seconds to return to the factory default
setting.
Level Mode Default Flash Rate by Module Group - Synchronized
Module Group
Front Quad 75 FPM
Rear Quad 75 FPM
L1 + L2
Front Quad 75 FPM
Rear Quad 75 FPM

Module Group Flash Rate Wires - Synchronized

Function Wire Color
GRN/WHT
BLU/BLK
Module Group Flash Patterns -
Order
10
11
12
13
14
15
16
L1 L2
Quad 75 FPM
Quad 75 FPM
L1 + L3
Cycle
Left/Right
TABLE 10
Module Group
Front
Rear
TABLE 11
Unsynchronized
Flash Pattern
1 Double 75 FPM
2 Triple 75 FPM
3 Quad 75 FPM
4 Quint 75 FPM
5 Triple Pop 75 FPM
6 Quad Pop 75 FPM
7 Single 150 FPM
8 Double 150 FPM
9 Triple 150 FPM
Quad 150 FPM
Quint 150 FPM
Triple Pop 150 FPM
Quad Pop 150 FPM
Single 375 FPM
NFPA Quad 77 FPM
Cycle Flash
TABLE 12
L3
Cycle
Cycle
L2 + L3 L1 + L2 + L3
Cycle Cycle
Cycle Cycle
Page 12 of 20