Resetting The Nbg6818 To Its Factory Defaults; Wireless Connections - ZyXEL Communications ARMOR G1 User Manual

• If the problem continues, contact your ISP.
The Internet connection is slow or intermittent.
• There might be a lot of traffic on the network. Look at the LEDs, and check
the NBG6818 is sending or receiving a lot of information, try closing some programs that use the
Internet, especially peer-to-peer applications.
• Check the signal strength. If the signal strength is low, try moving the NBG6818 closer to the AP if
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
• Reboot the NBG6818.
• If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
• Advanced Suggestion
Check the settings for QoS. If it is disabled, you might consider activating it.

14.5 Resetting the NBG6818 to Its Factory Defaults

If you reset the NBG6818, you lose all of the changes you have made. The NBG6818 re-loads its default
settings. You have to make all of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the NBG6818:
• Make sure the power LED is on.
• Press the RESET button for one to four seconds to restart/reboot the NBG6818.
• Press the RESET button for longer than five seconds to set the NBG6818 back to its factory-default
configurations.
If the NBG6818 restarts automatically, wait for the NBG6818 to finish restarting, and log in to the Web
Configurator.
If the NBG6818 does not restart automatically, disconnect and reconnect the NBG6818's power.
Then, follow the directions above again.

14.6 Wireless Connections

I cannot access the NBG6818 or ping any computer from the WLAN.
Chapter 14 Troubleshooting
NBG6818 User's Guide
144
Section 1.7 on page 14. If