Special Tools; General; Bearing, Ball, Inner Race; Bearing, Ball, Outer Race - GE XV-5A Installation, Operation And Maintenance Instructions

SECTION 3.
4!
SPECIAL TOOLS
3.1 GENERAL
a. This section lists, by function and numerical order, the special
tools applicable to work prescribed in this manual. Reference to the
tools in other sections of this manual are by the paragraph number indicated
in tbe functional tool list.
b. Use plastic or rawhide (never metal) -hammer heads when driving on
any part of the fan. Never lift heavy parts by hand. Use a chain or
powered hoist and special lifting yokes or straps. Apply pressure or
tension evenly to all bearing pushers or pullers. Tighten Jack screws
and attaching screws, bolts and nuts in small increments (opposing point
sequence).
CAUTION
A safety load check should be performed on all lifting
devices prior to initial and periodic recheck.
c. The following paragraphs.list the special tools.
The paragraphs
are arranged alphabetically according to part nomenclature and are sub-
divided on a functional basis. The numerical list of tools follow the
functional list.
FUNCTION
TOOL
NUMBER
FIGURE
3.2 BEARING, BALL, INNER RACE
REMOVAL:
Bearing Race Puller
4012028-612 3.4
3.3
EftRING, BALL, CTER RACE
Ii-FMOVAL:
Bearing Race Puller 112).2& 616 3.8
1-3.1
R-2