Assembly Of X353-5B; General Assembly Procedure; Scope; Assembly Tooling - GE XV-5A Installation, Operation And Maintenance Instructions

S.'(CTION 4.
ASSEMBLY OF X353-5B
4.1
GENERAL ASSEMBLY PROCEDURE
4.2 Scope
This section presents instructions for assembly of the individual
parts into sub-assemblies; assembly of these into components; and final
7.
assembly of the X353-5B system (Figure 4.1). The procedure presents the
sequence of assembly and calls out the quantity of parts but does not
list the part numbers.
When starting an assembly sequence, read and observe all NOTE and
CAUTION remarks for that sequence.
4.3 ASSEMBLY TOOLING
Where an assembly tool is required, the name of tlii tool will appear
in the sequence of use (in the Tooling Section of this manual).
)
1-4.1
R-2