NutriMill CLASSIC Owner's Manual page 2

Hopper Lid
Use during milling
for quiet operation
Hopper
Grain Inlet Cover
Variable Motor Speed
Control Knob
Variable Texture
Control Knob
Circuit Reset Button
Located at the bottom of the
Milling Module Unit
Separator Cup
Must be attached when
milling. For air filtration.
Prevents Flour Leakage.
Flour Bowl (Canister)
Large 20 cup capacity.
Large easy grip handles.
Locking Pin
This knob at the back of the mill firmly holds
the mill unit to the base. It can be removed
with a twist to separate sections for storage,
cleaning, or for use with the NutriMill Classic
optional Flour Bagger accessory.
*Inlet grommet and filter should be replaced every 2 years or as needed.
2
(Red)
Hopper Extension Ring
Comes packed inside the
flour bowl. Should always be
removed from bowl before
milling. Increases grain
capacity. Not necessary to use
when milling small amounts
Milling Module Unit
Inlet Grommet*
Rubber Gasket
Must be dry and in place
when milling. Helps air
flow. Prevents flour leakage
during milling.
Yes/No bowl position
indicator on front of base
helps position bowl into
place. Bowl must be pushed
in far enough to reveal
"YES" line on the base.
of grain
Bowl Lid
Air Filter*
Base