Owner's Manual


Table of Contents

Summary of Contents for NutriMill plus

  • Page 1 Owner's Manual...
  • Page 2 NutriMill Plus ® Grain Hopper Grain Hopper Mill Outlet Belt Flour Air Filter Tube Canister ON/OFF & Texture Control Fine/Coarse Switch Flour Canister 24 Cup Capacity Non-Slip Rubber Base 110-120 v (Cord coils under base) Flour canister lid birds eye view...
  • Page 3 Thanks for choosing this well crafted high speed flour mill. We know you will enjoy it for years to come. After all, it is a NutriMill ® Welcome to the NutriMill Family.
  • Page 4: Important Safeguards

    IMPORTANT SAFEGUARDS Please read all of these instructions thoroughly. When using electrical appliances, basic safety precautions should always be followed including the following: • Read all instructions. • To protect against risk of electrical shock DO NOT put motor base or power cord in water or other liquid.
  • Page 5 When turning on the mill, start with the motor switch in the down position, then turn it to high after the mill has started. FIRST TIME YOU USE YOUR NUTRIMILL® Mill at least 2 cups of wheat or other hard grain, then discard the flour and clean the canister.
  • Page 6 Turning the control knob to the left will close the grain feed gate, then turn off the motor. ® Put the hopper lid down and let it run. The NutriMill is designed to operate with the lid down for quieter milling.
  • Page 7 TEXTURE CONTROL NOTE: The instructions below are a general rule, results will vary depending on the size of the grain. The texture of your flour is managed by the flow rate of the grain and the motor speed. The lower the motor speed and the more open the feed gate (the more grains going in at a time), the coarser the flour will be.
  • Page 8 This attachment is included in your finished, remove the bag, seal it and store for later package. Use it to mill flour directly use. In addition to the flour bagger, the Plus includes into a bag. 10 free flour bags, and additional bags can be purchased from your NutriMill retailer.
  • Page 9 clean out any remaining particles. For best results, clean after every use. Clean the air filter by tapping out flour. Be sure there is no flour in filter if you wish to wash it. NOTE: Make sure the filter is thoroughly dry before using. Hand wash flour canister and lid, DO NOT put them in the dishwasher.
  • Page 10 Soy milk, tofu cheese, TVP meat substitute, casseroles, and bread are all ways of using soy. It has a higher oil content, but can easily be ground to flour by itself. NOTE: Soy, kamut, quinoa, and spelt must be dry before milling. THE NUTRIMILL® PLUS WILL MILL THE FOLLOWING: GLUTEN-FREE GLUTEN-FREE GRAINS GRAINS BEANS &...
  • Page 11 USE CAUTION WHEN MILLING THE FOLLOWING: Fill the hopper no more than ⅔ to ¾ with these as they produce more flour volume. • Dried Lentils • Legumes (generally) • Barley • Dried Sweet Corn • Dried Garbanzo Beans • Soybeans •...
  • Page 12: Warranty Information

    ® L’Chef, LLC warrants the NutriMill Plus mill to be free of manufacturing defects in materials and workmanship for a period of 7 years for parts and plastics and limited lifetime on motor and milling heads. Defective product will be repaired or replaced with a comparable model at our sole discretion upon receiving the defective product.

Table of Contents