Advertisement
Troubleshooting (continued)
Installing Multiple Fans with Independently Operating Remote Controls
To install multiple fans with independently operating remote controls, there is no need to
perform any pairing procedures. Each set of receiver/transmitter is already paired. Simply
install each receiver into a fan and use the appropriate transmitter to operate each fan.
If your remote is not working, see the "Remote does not work" section on the previous page.
Installing Multiple Fans Operating on a Single Remote Control
To have multiple fans operated by a single remote control, you must pair the transmitter to each
additional receiver. The receiver that shipped with your fan is already paired to the transmitter.
Note: To prevent faulty operation, you MUST disconnect power (at the wall switch,
breaker, or fan) from all other ceiling fans within range while pairing each fan.
For each additional fan, ensure that a compatible receiver is installed. Disconnect power from all
other fans while pairing. To pair: cycle power to the fan by turning power off and back on at
the wall switch (or circuit breaker if necessary). Within three minutes, press and hold both
the Fan and Light button for four seconds to pair/unpair the remote. If applicable, the fan
will turn on and the lights will flash and stay on to indicate successful pairing.
Installing One Fan Operating on Multiple Remote Controls
To have multiple remote controls operate one fan, you must pair each additional transmitter
to the receiver in the fan. The transmitter that shipped with your fan is already paired.
Note: To prevent faulty operation, please disconnect power (at the wall switch,
For each additional transmitter, cycle power to the fan by turning power off and back on at
the wall switch (or circuit breaker if necessary). Within three minutes, press and hold both
the Fan and Light button for four seconds to pair the remote. If applicable, the fan will
"Unpairing" Procedure for Faulty Operation of Remote Controls
If a transmitter is mistakenly operating a fan, you need to "unpair" the transmitter from that
Note: To prevent faulty operation, you MUST disconnect power (at the wall switch,
breaker, or fan) from all other ceiling fans within range while "unpairing" a fan.
Disconnect power from all other fans while "unpairing." Then, cycle power to the fan you
wish to "unpair" by turning power off and back on at the wall switch (or circuit breaker if
necessary). Within three minutes, press and hold both the Fan and Light button button
for four seconds to "unpair" the remote. If applicable, the fan will turn off and the lights
21
M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company
www.CasablancaFanCo.com
breaker, or fan) from all other ceiling fans within range while pairing.
turn on and the lights will flash and stay on to indicate successful pairing.
fan's receiver. The "unpairing" procedure is the same as the pairing procedure.
will flash and turn off to indicate successful "unpairing."
1.888.227.2178
Advertisement
