Installation - Aquion Micro Chrono Installation & Operating Instructions Manual

INLET & OUTLET

In case of high concentration of impurities in the inlet
water, we recommend the installation of a sediment filter,
ahead of the appliance.

We strongly recommend the use of flexible hoses to
connect the appliance to the water distribution system; use
hoses with a large diameter in order to limit the pressure
loss.

We strongly recommend to install a 3-valve bypass
system (not included with this product!) to isolate the
appliance from the water distribution system in case of
repairs. It allows to turn off the water to the appliance, while
maintaining (untreated) water supply to the user.
WITH 3-VALVE BYPASS SYSTEM (not included)
 Picture 1
 = mains water supply (untreated water)
 = inlet of appliance (untreated water)
 = outlet of appliance (treated water)
 = application (treated water)
1. Install the 3-valve bypass system.
2. Screw the connection kit with nuts onto the in/out ports
on the water softener (&); make sure to install the
gasket seals. Tighten the nuts firmly by hand.
3. Connect the 3-valve bypass system to the adaptors on the
in () and out () ports.
4. Connect the mains water supply to the inlet of the 3-valve
bypass system.
5. Connect the house/application to the outlet of the 3-valve
bypass system.
DRAIN

We recommend the use of a stand pipe with air trap.

To prevent backflow from the sewerage system into the
appliance, always install and use the included air gap with
double hose barb, to connect the drain hoses to the
sewerage system.

Always use separate drain hoses for the control valve
(evacuation of rinse water) and the brine cabinet's overflow.

Lay-out the drain hoses in such a way that pressure loss
is minimized; avoid kinks and unnecessary elevations.

Make sure that the sewerage system is suitable for the
rinse water flow rate of the appliance.
 Picture 2
1. Install the air gap to the sewerage system; it fits over a
32 mm pipe or inside a 40 mm pipe adaptor. Ensure a
permanent and watertight connection.
2. Connect a 13 mm hose to the drain elbow connection of
the control valve (); secure it by means of a clamp.
3. Run the drain hose to the air gap and connect it to one of
the hose barbs; secure it by means of a clamp. This drain
line operates under pressure, so it may be installed higher
than the appliance.
4. Connect a 13 mm hose to the brine cabinet overflow
elbow; secure it by means of a clamp.
EN - English

INSTALLATION

5. Run the drain hose to the air gap and connect it to the
other hose barb; secure it by means of a clamp. This drain
line does NOT operate under pressure, so it may NOT be
installed higher than the appliance.
Page 6