Table of Contents
Advertisement
Available languages
Available languages
5
TO ADJUST SEAT RECLINE
A TO RECLINE SEAT BACK: Lift both hand grips
behind the seat to release seat locks and slide the
seat back to desired position. Lower hand grips to
engage locks on both sides.
B TO RAISE SEAT BACK: From rear of buggy push
seat back to original upright or desired intermediate
position.
6
TO FOLD THE BUGGY
Fold the hood back, place the seat to an upright
position, remove contents of the shopping bag,
then fasten the harness.
A Using foot, lift up on brake pedal to release
primary lock.
B Using foot, push down on secondary lock lever.
C Grip handles and push forward and inward on buggy.
D Compress folded buggy and engage storage clip.
Use the carry strap to carry your buggy.
NOTICE: The buggy should always open and fold
easily. Do not force it. It may be necessary to re-read
the instructions.
ASSEMBLY INSTRUCTIONS
TO ATTACH THE HOOD
7
A Slide left hand and right hand hood connector onto the
hood bar connector located on the handle tubes.
B Place rear apron behind seat back.
C Extend hood and press down on side hinges to
lock in place.
8
TO FIT THE RAIN COVER
A Place the rain cover over the hood front.
B Attach two eyelets (one each side) to the
hood clips.
C Attach the two eyelets (one each side) to
the front legs.
9
TO RE-FIT THE SHOPPING BASKET
A Place bag on the 'X' frame under seat with
lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above
horizontal tie bar.
4
A
A
C
C
B
B
B
B
A
B
C
A
D
A
C
Advertisement
Table of Contents
