Whirlpool GU1200XT Technical Education page 19

Removing the Electronic Control Board
The electronic control board is located inside the console at the top of the dishwasher door.
1. Disconnect the ribbon connector and the wiring harness connectors from the electronic control
board. (Fig. 3-2)
2. Use a flat bladed screwdriver to depress the holding tabs at the left end of the control board
assembly while pulling up. (Fig. 3-3, Inset)
Fig. 3-2
Removing the Door Latch Assembly
Release the tabs securing the door latch assembly to the control panel and lift the assembly out. (Fig.
3-4, Inset)
Use a flat bladed
screwdriver to depress
the holding tabs
at the left end
of the control board
assembly while pulling
up as shown here.
Fig. 3-3
Inset
Fig. 3-4
15
Inset
Tab