Table of Contents
Advertisement
6. Test the E-Stop by opening the circuit a confirming the green LED goes off. You can now enable
back on the SCHP by moving (ON) so it will be the control software what will enable the
system. The Safety Charge Pump can be activated or deactivated depending on the jumper
position.
7. If something is not clear, do not hesitate in opening a support ticket and we will get back to
you as soon as possible:
Disclaimer:
Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC nor Arturo
Duncan are liable for any accidents resulting from the improper use of these devices. This product
is not a fail-safe device and it should not be used in life support systems or in other devices where
its failure or possible erratic operation could cause property damage, bodily injury or loss of life.
User's Manual
https://cnc4pc.com/contact/
Page 4
Advertisement
Table of Contents
Need help?
Do you have a question about the C11G and is the answer not in the manual?
Questions and answers