Download Print this page

Advertisement

Quick Links

Wing Span:42.3in/1075mm Flying Weight:900-1000g
Wing area:21sq.dm
Length:33.9in/860mm
CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children's reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model's assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Radio:4channels 5servos
Engine:2cycle 15-25

Advertisement

loading
Need help?

Need help?

Do you have a question about the Katana-15 and is the answer not in the manual?

Questions and answers

Summary of Contents for Turnigy Katana-15

  • Page 1 Wing Span:42.3in/1075mm Flying Weight:900-1000g Wing area:21sq.dm Radio:4channels 5servos Engine:2cycle 15-25 Length:33.9in/860mm CAUTION : this plane is not a toy! Before use , please carefully read this manual. ●First-time builders should seek advice from people having building experience in order to assemble the model correctly and to produce its performance to full extent .
  • Page 2: Install The Aileron Servos

    Install The Aileron Servos Cut away covering film for the servo. Put the servo into the hole. Pull out the servo extension from main wing.
  • Page 3 Connect the aileron and the main wing by hinges. Be sure to apply instant type glue to both sides of each hinges. Bent the pushrod as shown. Link the servo and tri-horns with pushrod and straper.
  • Page 4 Join The Wing Find out the holes on each sides of the fuselage as shown. Connect the main wings and the fuselage with joiner. Use two 5mm screws of each sides to ensure the wings fixed upto the fuselage. Install The Rudder & Elevator Connect the aileron and the stabilizer by hings, and glue them.
  • Page 5 Insert tail wheel into the rudder then apply instant glue. Apply instant type glue to both sides of each hinges of the rudder. Measure the right position and remove the film from the stabilizer.
  • Page 6 Measure the right position and remove the cover. Link the elevator servo to the elevator with pushrod. Use the same method to link the rudder servo to rudder.
  • Page 7: Install The Landing Gear

    Screw four TP screws to fix up the tail wheel on the tail of the fuselage. Install The Landing Gear Install the wheel cover, and fix it up to landing gear with TP screw. Fixup the landing gear strut to fuselage with 2 bolts.
  • Page 8: Install Fuel Tank

    Install Fuel Tank The process of fuel tank installation. Install the fuel tank into the fuselage, and fixup it with belt. Install the throttle servo and the throttle rod as shown.
  • Page 9: Glow Engine Installation

    Glow Engine Installation Install the engine with the hook on the engine equipment. Install escape-pipe to the engine as shown. Assemble The Canopy Canopy installation as shown.
  • Page 10 Install the cowling with four TP screws. Another way to install brushless motor.
  • Page 11 Adjustment Warning: Never jump this step before flight.
  • Page 12 CG & Control surface movement...
  • Page 13 FINISHED PICTURE...