Operating Your Compressor Nebulizer - Sanity Alergia STOP User Manual

OPERATING YOUR COMPRESSOR NEBULIZER

Caution!
The product must be used in accordance with the recommendations described
in the operator's manual.
The user may not implement any changes to the product.
Dear Customer – like any electrical device, our product may disturb the operation
of other electrical devices, such as cell phones, wireless telephones, routers – safe distance
from other electrical equipment with regard to device operation is approximately 1 meter.
Caution!
Prior to initial operation, the nebulizer should be thoroughly cleaned.
1. Place your compressor nebulizer on a flat and stable surface. Be sure that you can easily reach the
controls when you are seated.
Important: Prior to initial operation, the nebulizer should be thoroughly cleaned referring
to the "Cleaning Procedures" in the manual.
2. Gently twist the top part of the nebulizer bottle counter-clockwise
to disassemble the nebulizer bottle.
3. Fill the bottom section of the nebulizer bottle with the medication
prescribed by your physician. Be sure that the cone is put inside
the bottom section and an upper part is yellow sleeve with the
tabs pointing upwards.
4. Gently twist the top part clockwise to and fill medication
re-assemble the nebulizer.
Be sure the two sections fit well.
5. Attach one end of air tube to the base of the nebulizer bottle.
6. Attach the other end of air tube to the air tube connector located
on the front of the compressor.
7. Attach mouth piece or mask per your choice to the top section of
nebulizer.
8. Plug the power cord into an appropriate electrical outlet.
Make sure at this stage, the power switch is at "OFF" status.
9. Press power switch to begin your prescribed treatment.
10. After the end of inhalation, turn the machine off and turn it from the mains.
Important: The compressor motor has a thermal protector which will shut off the unit before the
unit is overheated. When the thermal protector shuts the unit off, please:
a. Set the switch in the OFF position.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment.
Make sure the air openings are not obstructed.
11. When treatment is finished, shut off the unit and unplug it from the electrical outlet.
Place cone
inside and fill
medication
16