Operating Your Compressor Nebulizer - Sanity AP 2116 User Manual

OPERATING YOUR COMPRESSOR NEBULIZER

Caution!
Prior to initial operation, the nebulizer should be thoroughly cleaned.
1. Place your compressor nebulizer on a flat and stable surface. Be sure that you can easily reach the
controls when you are seated.
2. Open the clear bag and remove the inside accessories.
Caution: Prior to initial operation, the nebulizer should be
thoroughly cleaned referring to the cleaning
procedures in the manual.
3. Gently twist the top part of the nebulizer counter-clockwise to
disassemble the nebulizer.
4. Fill the bottom section of the nebulizer with the medication prescribed by your physician.
Be sure that the cone is put. Place cone inside inside the bottom section and fill medication.
5. Gently twist the top part clockwise to fill medication reassemble the nebulizer. Be sure the two
sections fit well.
6. Attach one end of air tube to the base of the nebulizer.
7. Attach the other end of air tube to the air tube connector located on the side of the compressor.
8. Attach the nebulizer to the top section of nebulizer.
9. Plug the power cord into an appropriate electrical outlet. Make sure at this stage, that the power
switch is at "OFF" status.
10. Press power switch to begin your prescribed treatment.
Caution!
The compressor motor has a thermal protector which will shut off the unit before the unit is overheated.
When the thermal protector shuts the unit off, please:
a) switch off the unit,
b) unplug the unit from the electrical outlet,
c) wait 30 minutes for the motor to cool down before another treatment.
11. When treatment is finished, shut off the unit and unplug it from the electrical outlet.
Caution!
The product must be used in accordance with the recommendations described
in the operator's manual.
The user may not implement any changes to the product.
Dear Customer – like any electrical device, our product may disturb the operation
of other electrical devices, such as cell phones, wireless telephones, routers – safe distance
from other electrical equipment with regard to device operation is approximately 1 meter.
Place cone
inside and fill
medication
15