Table of Contents
Advertisement
RE MO TE CONT R OL H OU SIN G MO U NTIN G IN S TR U C TION S
1
1. Cut a 5-5/16" x 4-1/2" x 11-1/16" (133mm x 114mm
x 281mm) opening in the location where the
control is to be positioned.
2. Thoroughly clean and dry the mounting surface
around the control cut-out opening on which the
décor face will be applied.
NOTICE: The control face will not properly
adhere to an unclean surface.
3. Remove the décor face from the unit by removing
the two nuts
from the back of the housing.
1
I N S T A L L A T I O N
Apply a food grade silicone
along the outside edge of
the round well support flange.
FLEXIBLE WATER-
TIGHT TETHER
4. Making sure "TOP" etching is at the top, route
5. Remove the protective film from the mounting
MN-35890 (Rev. 3) 04/16 • Round Wells • 7
control housing through opening cut in step 1.
Secure the décor face housing to the control
housing using the nuts removed in step 3.
tape on the inside flanges of the décor face and
apply the décor face to the mounting surface. Two
holes are provided in décor face for additional
mounting screws (not provided) if desired.
Advertisement
Table of Contents
