Changing A Cycle Setting; Adding A Dish During; A Cycle - Whirlpool 9400 Series Use And Care Manual

Changing a cycle setting
You can change
a
setting anytime during any cycle.
During the first minute of a
cycle
During the first minute of
a cycle
the dish-
washer is filling with water and the wash
action has not started.
1.
Select
a
new cycle and option(s).
2. Be sure the detergent dispensers are
filled properly for the new cycle.
After the first minute of a
cycle:
1.
Press the CANCEL/DRAIN pad. The
dishwasher will go into a 2 minute drain
cycle, if needed.
2. Select a new cycle
and
option(s).
3. Be sure the detergent dispensers are
filled properly for the new cycle.
4. Press the START pad. The dishwasher
will start the new cycle.
SELECT
m
PRESS
m
D- 1
SELECT
m
PRESS
w .* .
w
a. l
Adding a dish during a cycle
You can add an additional item to the dishwasher anytime while the ADD A DISH signal light
is on.
1.
Lift up on the door latch to unlatch the
door and stop the cycle. Wait a moment
for the spray action to stop before open-
ing the door.
2. Open the door and add the dish.
3.
Close the door.
Do not latch it.
Wait
30 seconds for air in the dishwasher to
warm up. This helps reduce the amount
of moisture that can come from the vent
when restarting the cycle.
4. Press door in to latch it. The dishwasher
will start where it stopped.
NOTE: The cycle will be cancelled if you
accidentally touch the CANCEL/DRAIN pad
while closing the door. Press the CANCEU
DRAIN pad again, then press the START
pad to restart the cycle.
8