Table of Contents
Advertisement
If You Need Assistance
Or Service
This section is designed to help you save the cost of
a
service call. When calling our Con-
sumer Assistance
Center for help or calling for service, please provide a detailed description
of the problem, your appliance's complete model and serial numbers and the purchase date.
(See page 2.) This information
will help us respond properly to your request.
1. Before
calling
for assistance
. . .
Please check the chart below for problems you can fii. It could save you the cost
of a service call.
PROBLEM
CHECK THE FOLLOWING
Dishwasher does not
Is the
door tightly closed and securely latched?
run or stops durlng a
cycle
Has
the cycle been set correctly? See page 6.
Has a household fuse or circuit breaker blown or tripped?
Is the delay feature on?
If the motor has stopped because of an overload, it will auto-
matically reset itself within a few minutes. If the motor does not
start, call for service.
Is the water supply turned on?
Is the dishwasher wired into a live circuit with the proper
voltage?
Dishwasher seems to
The dishwasher
will run longer while heating the water. This is
run too
long
normal for lower incoming water temperatures.
See page 13.
Dishwasher
will
not fill
Is
overfill protector stuck in "up" position? Overfill protector
should move up and down freely. Press down to release.
Water remains In
Wait for the cycle to finish. A small amount of water remaining
dishwasher
is normal.
Check the drain air gap (ii installed). If it is clogged follow the
manufacturer's
cleaning instruction.
Detergent remains in
Has the cycle completed?
covered
section of
dispenser
Is the detergent fresh and dry without lumps?
Is the bottom rack in backwards? The rack bumpers should
face the door.
Dishes are not as dry
as you expected
Grinding, grating,
crunching
or buzzing
sounds
Is the rinse agent dispenser empty? Using a rinse agent greatly
improves drying. See page 12.
Do not use Air Dry option on the next load. See page 13.
Has a hard object entered the POWER CLEANTM module?
The sound should stop when the object is ground up.
continued on next page
27
Advertisement
Table of Contents
