Table of Contents
Advertisement
On some models:
1.
Press the flexible clear top of the Fill
Indicator Cap to draw rinse agent
into cap.
NOTE: You may need to press cap two
or three times to remove all of the air
bubbles from the cap.
2. When rinse agent does not show in cap,
even after pressing flexible cap several
times, dispenser needs refilling.
To fill dispenser
You do not have to wait until the dispenser
is empty to refill it, but do not overfill it. The
dispenser will hold 6 ounces (175 ml) of
rinse agent. Under normal conditions, this
will last about 3 months.
1. Make sure the dishwasher
door is fully
open.
2. Remove the Fill Indicator Cap.
3. Add rinse agent to the dispenser. Do not
fill past the smallest opening in the lower
part of the dispenser.
If you overfill, excess rinse agent can
come out. This will not harm the dish-
washer, but could cause over-sudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace the Fill Indicator Cap and keep it
tightly closed.
NOTE: Your dishwasher
is designed to use
a liquid rinse agent. You do not need to use
a solid or bar-type rinse agent.
7
Press flexible
clear top. on
rome models
Keep rinse agent
dispenser filled for
best
drying results
Da not fill past
smallest opening /
Quiet
operating
tips
To avoid thumping and clattering noises
during operation:
l
Make sure lightweight
load items are
secured in the racks.
. Make sure pot lids and handles, pizza
pans, cookie sheets, etc. do not touch
interior walls or interfere with the spray
arm's rotation or cover the spray tower.
. Load dishes so they do not touch one
another.
NOTE: Keep sink drain plugs inserted during
dishwasher operation to prevent noise
transfer through drains.
16
Advertisement
Table of Contents
