System Installation - Pro-Aqua PRO-S-80E Owner's Manual

SYSTEM INSTALLATION

3. Lubricate the riser tube located on the opening of the tank.
4. Install the upper basket on the bottom of the valve by lining up the
tabs, pressing in, then turning the basket counterclockwise to lock it in
place.
5. Place the upper basket over the distributor tube and push the valve
on the tank. Thread the valve on the tank by turning it clockwise.
Be sure not to cross-thread the valve on the tank. The valve should
thread easily in the tank. If not, it may be cross-threaded.
6. Tighten the valve hand tight, then snug it further by tapping it with
the palm of the hand. DO NOT use tools to tighten the valve or
damage could occur.
- 8 -